Dolphin1412FDM production is a fixed type and low noise x-ray flat panel detector based on CMOS. CMOS sensors use a single crystal silicon process for chip fabrication. Direct integral amplification within pixel cells leads to lower electronic noise, higher signal-to-noise ratio, and higher quantum detection efficiency (DQE) than amorphous silicon, so CMOS sensors are particularly suitable for low-dose imaging scenarios.
• Electronic noise is lower
• Higher signal-to-noise ratio
| Technology | |
| Sensor | CMOS |
| Scintillator | CSI |
| Active Area | 120 x 140 mm |
| Pixel Matrix | 2400 x 2802 |
| Pixel Pitch | 50 μm |
| AD Conversion | 14 bits |
| Interface | |
| Communication Interface | Optical Fiber |
| Exposure Control | Pulse Sync In (Edge or Level) / Pulse Sync Out (Edge or Level) |
| Work Mode | Software Mode / HVG Sync Mode / FPD Sync Mode |
| Frame Speed | 29fps (1x1) |
| Operating System | Windows7 / Windows10 OS 32 bits or 64 bits |
| Technical Performance | |
| Resolution | 10.0 lp/mm |
| Energy Range | 40~160 KV |
| Lag | 0.01% 1st frame |
| Dynamic Range | ≥ 73dB |
| Sensitivity | 100 lsb/uGy |
| SNR | 48 dB @(20000lsb) |
| MTF | 90% @(1 lp/mm) |
| 82% @(2 lp/mm) | |
| 74% @(3 lp/mm) | |
| DQE (2uGy) | 65% @(0 lp/mm) |
| 48% @(1 lp/mm) | |
| 37% @(2 lp/mm) | |
| Mechanical | |
| Dimension(H x W x D) | 171 x 171 x 37 mm |
| Weight | 3.2 Kg |
| Sensor Protection Material | Carbon Fiber |
| Housing Material | Aluminum Alloy |
| Environmental | |
| Temperature Range | 10~35°℃ (operating); -10~50℃(storage) |
| Humidity | 30~70% RH(non-condensing) |
| Vibration | IEC/EN 60721-3 class 2M3(10~150 Hz,0.5 g) |
| Shock | IEC/EN 60721-3 class 2M3(11 ms,2 g) |
| Dust and Water Resistant | IPX0 |
| Power | |
| Supply | 100~240 VAC |
| Frequency | 50/60 Hz |
| Consumption | 8 W |
| Regulatory | |
| CFDA (China) | |
| FDA (USA) | |
| CE (Europe) | |
| Application | |
| Medical |
Dental CBCT |
|
Mechanical Dimension |
|
Write your message here and send it to us
